language

What are the operating precautions for the deep loosening machine?

Release time:

2024-01-17

It is prohibited for staff to work while fatigued, under the influence of alcohol, or at night. Staff using deep loosening machines must not lend them to individuals who do not understand safe operating procedures.

1. It is prohibited for staff to work while fatigued, under the influence of alcohol, or at night. Staff using the deep loosening machine must not lend it to individuals who do not understand safe operating methods.
2. Staff operating the deep loosening machine must be familiar with the operation manual and strictly follow safe operating procedures.
3. Staff using the machine must pay attention to safety warning signs on the machine and carefully read the content of these signs.
4. Every time staff use the deep loosening machine, they must wear appropriate protective clothing as required to prevent entanglement by moving parts, which could lead to safety accidents.
5. Before each use, it is essential to check whether there is enough lubricating oil in components such as the engine and transmission box of the deep loosening machine. Check if any bolts on each part are loose or have fallen off. Ensure that operational components like the engine, transmission box, clutch, and braking system are still functioning properly. The gear lever should be in neutral position, and exposed rotating parts should have protective covers.
6. When installing tools on the deep loosening machine, they must be symmetrically placed left and right with cutting edges facing forward. It is recommended to securely install bolts, pins, etc., to ensure that the deep loosening machine can operate safely.
7. The height of the resistance rod can be adjusted at any time according to actual working conditions to ensure a stable position of the machine body and prevent excessive tilting of the engine that could lead to poor lubrication and damage.
8. After starting the engine of the deep loosening machine, it should run under no load for five to ten minutes. It is advised not to operate at high speeds or heavy loads within one or two hours before work; this can also extend its service life. If there is a runaway situation when starting the engine, immediately cut off fuel supply and turn off the engine.
9. When working in fields such as ditches or channels with a deep loosening machine, low-speed operation should be used. During operations inside large areas like greenhouses, ensure good ventilation for air circulation and exhaust gas discharge.

How to maintain seeder parts

None

How to maintain seeder parts

None